✔️PROTECTS CLEATS FROM WEAR

✔️EASY APPLICATION, BONDS TO ANYTHING

✔️USED BY MLB, NCAA, & TEAM USA PITCHERS

✔️WORKS ON ALL FOOTWEAR

✔️ MADE IN USA WITH FULL-SEASON WARRANTY

Application Process

STEP 1: MARK AREA – Use marker to make an outline of the area to be protected.

STEP 2: PREP – Clean and sand the area well

STEP 3: EQUALIZE CARTRIDGE & TIP – Tuff Toe is a two-part application that needs to mix simultaneously at the time of application. If the parts are not equal, the application will fail. To ensure equalization, push material out of both cartridges until they are both extracting equally into the mixing nozzle.

STEP 4: APPLY BASE – Apply to base first and use the stick provided to smear evenly.

STEP 5: APPLY TO TOE – Use a fresh mixing tip. Apply from the corner down immediately remove the tape. Pull carefully so that you don't mess up your application.

STEP 6: ROTATE – Rotate the cleat for 1-2 mins with the toe tip pointed down to allow the material to spread evenly and avoid runs.

STEP 7: CURE FOR 24 HOURS – Material will be 80% cured after 90 minutes, but please allow 24 hours for a full cure.